Paradyne COMSPHERE 6700 SERIES - Manual (Page 23)

Configuration Files and Interfaces
3-6 Issue 2 December 1996
Automatically Connecting
Interfaces
Use Interface on the Network Configuration main menu to set
up serial interfaces to automatically connect at system startup.
Also use this command to remove interfaces from the automatic
connection list.
NOTE:
You must configure the devices and the COMSPHERE
6700 Series NMS interfaces before you can use this
procedure to automatically connect those interfaces. Also,
the COMSPHERE 6700 NMS must be running.
To set up automatically connecting interfaces, choose Interface
from the Network pull-down menu. The Auto Connect Interfaces
dialog box appears, as shown in Figure 3-5.
Figure 3-5. Auto Connect Interfaces Dialog Box