Panasonic DMR-XS350 - Manual (Page 97)

97
RQT9439
C
onv
e
ni
e
nt
fun
c
ti
ons
[Required^setting]
≥“Digital Audio Output” in the Setup menu (> 87)
≥When this unit is connected to an amplifier with an optical digital audio cable and connected to a television with an HDMI cable, you can enjoy
the highest quality of audio from the disc by setting “HDMI Audio Output” to “Off” in the Setup menu ( > 89). In this case audio is only output
from the amplifier not the television.
≥Before purchasing an optical digital audio cable (not included), check the terminal shape of the connected equipment.
∫ With OPTICAL
Connecting VCR or Set Top Box (Terrestrial receiver, CATV, etc.)
MPONENT
DEO OUT OUT
Y
R P
B P
AV1
(TV)
VIDEO
RGB/S VIDEO


AV2
(EXT)
VIDEO
RGB/S VIDEO


AV
This unit’s rear panel
VCR or Set Top Box’s
rear panel
21-pin Scart cable
Connect the unit directly to the television
If you connect the unit through an AV selector or
video cassette recorder to the television, video
signal will be affected by copyright protection
systems and the picture may not be shown
correctly.
≥When connecting to a television with a built-
in VCR
Connect to the input terminals on the television
side if there are both television and VCR input
terminals.
Television
VCR
This unit
DO NOT
Connecting an amplifier with a digital input terminal
LNB LNB
IN 2 IN 2
OPTICAL
DIGITAL AUDIO OUT (PCM/BITSTREAM)
COMPONENT
VIDEO OUT
AUDIO
OUT
VIDEO
L
R
Y
R P
B P
OPTICAL IN
Optical digital audio
cable
Do not bend sharply
when connecting.
This unit’s rear
panel
Insert the cable so its
shape fl ts correctly
Into the terminal.
Amplifier’s rear panel
DMRXS350EG-RQT9439-L_eng.book 97 ページ ２０１０年１月１４日 木曜日 午後４時２０分