Performance Teknique ICBM-1-TOUCH - Manual (Page 16)

TV½У КХ Ж д Л ь ¹ ¦ Д Ь
Clock
Check the clock when the machine is in idle state.
In idle state, press DISP button on the panel or remote once to
display clock as follows:
2 Play Preset Channels
Press or open TV touch menu, touch CH+ and CH- to select
previous or next channel. When the channel number is the maximum one, the
system will change to the minimum channel. For example, if there is altogether
18 channels, and we are using channel 18 now and continue to select upward,
the channel will transfer to channel 0.
3. Fine Tuning
Touch Left or Right fine tuning button or use the remote controller. If
the key is pressed continuously, the tuning effect will change continuously.
4 Manual Storage
Use touch key STORE or press ENTER on the remote, STORE XX will
be displayed. Press CH+ and CH- channel selecting keys on the remote) to
select wanted channel, then press STORE or ENTER.
5 Blue Screen
Quite large noises will occur when the TV signal is too weak. To avoid
this situation, one can start BLUE SCREEN function. The screen will turn to
blue and mute when the signal is too weak.
OPERATION
1 : MENU SELECT
2 : MENU ADJUST
3 : DISP STORY
4 : SRC EXIT
08:08
Setting the Clock
Press DISP button twice in idle state to enter clock setting, the clock
is indicated as red, which will glitter while the time is adjusted.
Use menu adjusting keys to select position; use volume keys to
adjust the time. The system will be in idle state 5 seconds after the operation.
27 28
Precautions:
1 At most 100 channels can be stored in this machine.
2 If the receiving effect is bad, check the connection of antenna.
3 If the bad effect is caused by weak signal or high-speed driving,
it does not mean something is wrong with this machine.
Input numbers to select channel. If the first number is input and there is
no further input for 2 seconds, the system will seek channel corresponding to
the first number.