Performance Teknique ICBM-1-TOUCH - Manual (Page 4)

Reset the micro-processor
Press RESET to initialize the micro-processor.
The reset operation is needed only when:
The machine is used for the first time after installation.
This machine does not work well.
Abnormal or incorrect information appears in the monitor.
1 Turn the power switch to OFF.
2 Press RESET with penpoint or other pointed objects.
Precautions
Please turn the power switch to OFF before you press RESET when completing
the connection or all the memories have been lost and need a reset.
Matters to Note Matters to Note
Replacing the Lithium Battery
Precautions
Keep the battery out of the reach of children. Should the battery be swallowed,
consult doctors immediately.
Wipe the battery with dry cloth to assure a good contact.
Please insert the battery with correct polarity
Do not hold the battery with metallic tweezers, otherwise a short-circuit
may occur.
Precautions:
The battery may explode if mistreated. Do not recharge, disassemble the battery or
put it in fire.
Installing Steps
Take out the battery buckle
Press the battery buckle and pull it out.
Normally, the battery can last for about 1 year. (Its lifespan may be
shortened due to different working conditions.When the battery power
becomes weak, its function will be narrowed.Replace it with a new Cr2025.
Replace the battery
Put the battery in the buckle with its anode upward
Insert the battery buckle
Push the buckle to its original
position.
Back of the remote
Battery tank
Battery
Transparent slice
The Use and Maintenance of Remote Control
Take out the projecting slice at the bottom of the card batterywhen it is used for
the first time.
3 4