Performance Teknique ICBM-1-TOUCH - Manual (Page 19)

MP3
Mp3 is the abbreviation of MPEG audio layer3, which is the standard of audio
compression technology.
Mp3 files on CD-ROM CD-R and CD-RW can be played in this machine. Disks
compatible with ISO9660 level 1 and 2, or with ROMEO and JOLIET system
can also be played.
Recorded disks with multi sections can be played.
Mp3 files are incompatible with the transporting of read-in data.
The max char width of the file name (including the extending name .Mp3)
is 32 (counting from the first char).
The max char width of the folder name is 32.
If the file is recorded through ROMEO and JOLIET system, only the former
32 char are displayed. While playing disks with Mp3 and CD-DA, such as
CD-EXTRA and MIXED-MODE CD, the system can only switch between Mp3
and CD-DA.
The selected folder sequence of playing and other operations will be the
sequence to write in the software. So the anticipated sequence of playing should
not conflict with the actual playing sequence. However, there are indeed some
softwares in which playing sequence is allowed to set.
The file is compatible with Id3 Label version 1.0 and 1.1, so as to display the
music titles and authors. The enhancing function is valid only when playing
Mp3 in 32,44.1 and 48 Khz. Sample frequencies 16,22,05,24,32,44.1,48KHz
can be played.
The tone of Mp3 file can usually be bettered when the bit rate is increased. This
machine can play recordings between 8KBPS and 320KBPS. But in order to
enjoy good tone, we recommend disks over 128KBPS.
IMPORTANT:
While naming an Mp3 file, add relevant extending name .mp3.
This machine will play files with .mp3 as Mp3. Do not use this extending name
on non-mp3 files so as to avoid noises and other problems.
¸ ½ ¼ У Ч К С ¶ ¸ ½ ¼ У Ч К С ¶
Do not put the remote on panels, steering wheels, or where with direct
sunshine. The temperature in these places are high in summer and the
remote may be distorted.
If the car is parked in the sun, put the remote in the tool box or other
places away from the sunshine. In the sunshine, the signal from the remote
may not be received correctly by the host machine, you have to put the remote
near the sensor on the host panel.
About LCD
Do not press LCD, which may distort the pictures or arouse problems.
Pictures become blurred, or even the LCD is harmed.
About Cleaning LCD
Use soft cloth with a little water to clean LCD.
Do not use solvents like gas, thinner, detergent in the market or static
electricity-resisting sprayer.
Do not use this machine when the temperature is below -15 or over 45.
If your car is parked in a very cold or hot place, pictures may not be clear.
This is not the question of LCD. Pictures will become clear again once
the temperature comes to normal.
There may appear static blue or red points called bright spots which
can appear on any LCD. LCD is a very fine apparatus, 99.99% of
which is normal, with only less than 0.01% defect leading to those points.
They will not influence your appreciation of pictures, however.
Matters to Note about Remote Controller
33 34
Supplementary Information Supplementary Information