Pioneer DV-C302D - Manual (Page 12)

12
Rear Panel
OPT.
DIGITAL OUT
AUDIO OUT (2CH)
R
1 2
L
SUB WOOFER
CENTER
AUDIO OUT (5.1CH)
R
FRONT
L
SURROUND
VIDEO OUT
Y
P B
P R
S-VIDEO OUT CONTROL
IN
AC IN
VIDEO
OUT
SELECT
COMPONENT
VIDEO OUT
1 2
8 9
3 4 5 6
7
1
CONTROL IN jack
Use to connect this player to another component
bearing the Pioneer
Î mark. This lets you control
this unit as though it were a component in a system.
Player operations are then performed by pointing the
remote control at the component that the player is
connected to (page 19).
2
VIDEO OUT jack
Connect to the video input on a TV or monitor or AV
amplifier or receiver with video input capability.
When using this jack, be sure to set VIDEO OUT
SELECT to the left position (page 19).
3
S-VIDEO OUT jack
If your TV or monitor has an S-video input, clear
picture reproduction is possible by connecting the
player to your TV or monitor via the S-video jack.
When using this jack, be sure to set VIDEO OUT
SELECT to the left position (page 19).
4
COMPONENT VIDEO OUT jacks
If your projection monitor, projector or similar
component has component video inputs, you can
produce a higher quality picture on your projection
monitor or projector by connecting to the component
video outputs on this unit. When using these jacks,
be sure to set VIDEO OUT SELECT to the right
position (page 19).
5
AUDIO OUT (2 CH) jacks
Use to output two-channel audio (analog) to the
audio stereo inputs on a TV or stereo amplifier. If you
are connecting to a receiver that has both digital and
analog input jacks for DVD player connection, it may
be beneficial to make both connections (pages 18).
6
AUDIO OUT (5.1 CH) jacks
Use to output 6 discrete audio channels of decoded
digital audio to a receiver or amplifier with discrete
audio inputs (page 18).
7
AC IN power cord connection terminal
Use to connect the power cord to the wall outlet
(page 15).
8
VIDEO OUT SELECT switch
Use to set which output is used to output the video
signals. Select either video/S-video or component
video signal output depending on the connections
you make (page 19).
9
DIGITAL OUT jacks (coaxial, optical (OPT.))
Use to output the digital audio signal recorded on
discs. You can output the digital signal via either
coaxial or optical output jack to an AV amplifier or
receiver (page 17).