Pioneer DV-C302D - Manual (Page 28)

28
Using the Setup Screen Menus
The procedure on page 28 and 29 describes how to
operate the menus on the Setup screen. These menus
are used to set and adjust a number of system settings.
The various functions that can be adjusted are covered
throughout this manual. The procedure on this page
provides a basic outline for using the Setup screen
menus.
When setting up for the first time
It is recommended to set up player using the [Setup
Navigator] (page 20). If you selected “Not Used” when
the [Setup Navigator] appears, you may still set up the
player using the [Setup Navigator] in the General menu
screen.
If you choose not to use the [Setup Navigator], be sure
to make the necessary settings in the Setup screen
Audio 1, Audio 2, Video, and Language menus as
described on the following pages.
Some DVDs start playing automatically when loaded in
the player. If a DVD has been loaded, be sure to press
STOP
7 before proceeding.
1
Press ( STANDBY/ON on the front panel)
to turn the player on.
2
Press SETUP.
The Setup screen appears.
3
Use the cursor buttons (
2/3) to select the
menu you want.
As each menu is selected with the cursor, the
settings appear below the menu heading.
4
Press the cursor button (
∞) to enter the
menu.
The top item within the menu becomes highlighted.
5
Use the cursor buttons (
5/∞) to select the
setting you want to change.
The options available for each setting appear to the
right when the setting is selected. The current
setting appears with the setting indicator lit.
6
Press the cursor button (
3) to enter the
setting options.
• Not all menu options can be changed while a disc
is playing. In these cases, the options appear
grayed out on the screen and cannot be adjusted.
To change these settings, press STOP
7 first
before pressing SETUP.
• Operating the menu after pressing STOP 7 may
cancel the resume function.
• Some menu options are not immediately
effective if set while a disc is playing. To make
these settings effective, stop playback and then
start again, or change the settings while the disc
is stopped.
continued
5
5
5
5
4 ¢
1
8 7 e E
¡ 3
4,5
2
1
3,6
Adjusting Audio
and Video
Settings
STANDBY/ON
4 1 ¢ ¡
0
1
8 7 3
(Example)
Dolby Digital Out – Dolby Digital
DTS Out – Off
Linear PCM Out – 96kHz 3 48kHz
MPEG Out – MPEG 3 PCM
Audio1 General Language Video 2
SETUP Move Exit
Setup audio
Digital output format/tone adjust
DTS Out -
96kHz PCM Out – 96kHz 3 48kHz
MPEG Out – MPEG 3 PCM
Audio1 General Language Video 2
Move Exit
Dolby Digital 3 PCM
Dolby Digital
SETUP
Dolby Digital Out
Switch Dolby Digital audio mode
(Example)
DTS Out -
Linear PCM Out – 96kHz 3 48kHz
MPEG Out – MPEG 3 PCM
Audio1 General Language Video 2
Move
Dolby Digital 3 PCM
Output Dolby Digital
Dolby Digital Dolby Digital Out
SETUP Exit ENTER Select
(Example)