Polycom DOC2230A - Manual (Page 25)

3-1
3
Initial System Configuration
The MGC-50/MGC-100 requires basic configuration before you can start
running conferences.
Initial IP Configuration
The system is shipped with a default IP address: 129.254.4.8. Ordinarily,
you need to change the MCU’s default IP address to the IP address
appropriate for the site's LAN. This section describes how to modify it using
a monitor and terminal to connect directly to the MCU.
To modify the MCU default IP address to the site’s IP address:
1. Remove the Main Control Module cover.
Figure 3-1: MGC-100 Rear Panel
Initial IP
Configuration
Installing the
MGC Manager
Connecting
to an MCU
Configuring the
Network Services
Defining an MCU
Starting the MGC
Manager
NET
A
B
LAN ALARMS COM 1 COM
MUSIC
LINE IN
L N K T / R
KB0
10/100 Mbits