Pioneer S-DV900ST - Manual (Page 73)

Other connections 11
73
En
English
Italiano
Français
Nederlands
Español
Deutsch
• Connect the LINE 1 (IN) jacks to the
analog outputs of an external playback
component.
These include components such as a VCR or
cassette deck. Connect using RCA pin-plug
stereo cables. See also
Reducing the TV and
line signal levels below.
• Connect the LINE 1 (OUT) jacks to the
analog inputs of an external recording
component.
These include components such as a
cassette deck, VCR, MD or another recorder
with analog inputs. Connect using RCA pin-
plug stereo cables.
• Connect the OPTICAL DIGITAL OUT
jack on the rear panel to the optical digital
input of an external recording
component.
• Connect the LINE 1 (OPTICAL IN) jack
on the rear panel to the optical digital
output of an external playback
component.
These include digital components such as an
MD player, digital satellite, or a game system.
Connect using a optical digital cable (not
supplied).
Reducing the TV and line signal
levels
• Default setting: ATT 6dB
Some sources may produce a high signal
level which may produce unpleasant
distortion from the speakers. In such cases,
you may need to reduce the signal level of the
auxiliary source (connected to the
TV or LINE
1 or LINE 2 analog inputs) by switching on the
attenuator.
1 Switch the system into standby.
2 Press SYSTEM SETUP.
3 Use the / (cursor left/right)
buttons to select ‘TV ATT?’ or ‘LINE1 ATT?’
or ‘LINE2 ATT?’, then press ENTER.
4 Use the / (cursor up/down)
buttons to select ‘ATT Off’, ‘ATT 6dB’ or
‘ATT 10dB’.
If the ATT 6dB setting still results in distorted
sound, try the ATT 10dB setting.
5 Press ENTER to confirm.
CAL TAL N
S-VIDEO OUT
VIDEO
OUT
L
R
LINE1
LINE1 OUT TV IN
AUDIO
VIDEO L
R
AUD
LINE1 IN LINE2 IN
AUDIO
OUTPUT
AUDIO
INPUT
Tape deck, etc.
XV–DV900 / XV–DV700
OPTICAL
DIGIT
AL
OUT
LINE2
OPTICAL
DIGIT
AL
IN
LINE
1
NS03_ZFL.book 73 ページ ２００３年７月３１日 木曜日 午後７時０分