Pioneer S-DV900ST - Manual (Page 80)

Additional information 12
80
En
Proper installation and
maintenance of this system
Hints on installation
We want you to enjoy using this system for
years to come, so please bear in mind the
following points when choosing a suitable
location for it:
Do...
Use in a well-ventilated room.
Place on a solid, flat, level surface, such
as a table, shelf or stereo rack.
Don’t...
Use in a place exposed to high
temperatures or humidity, including near
radiators and other heat-generating
appliances.
Place on a window sill or other place
where the system will be exposed to direct
sunlight.
Use in an excessively dusty or damp
environment.
Place directly on top of an amplifier, or
other component in your stereo system
that becomes hot in use.
Use near a television or monitor as you
may experience interference—especially
if the television uses an indoor antenna.
Use in a kitchen or other room where the
system may be exposed to smoke or
steam.
Use on a thick rug or carpet, or cover with
cloth—this may prevent proper cooling of
the system.
Place on an unstable surface, or one that
is not large enough to support all four of
the unit’s feet.
Cleaning the pickup lens
The DVD player’s lens should not become
dirty in normal use, but if for some reason it
should malfunction due to dust or dirt,
consult your nearest Pioneer authorized
service center. Although lens cleaners are
commercially available, we do not
recommend using them since some may
damage the lens.
Problems with condensation
Condensation may form inside the player if it
is brought into a warm room from outside, or
if the temperature of the room rises quickly.
Although the condensation won’t damage the
player, it may temporarily impair its
performance. For this reason you should
leave it to adjust to the warmer temperature
for about an hour before switching on and
using.
Moving the system unit
If you need to move the main unit, first remove
a disc if there’s one in the player, then press
STANDBY/ON on the front panel to turn
the system off. Wait for Good Bye to
disappear from the display, then unplug the
power cable. Never lift or move the unit during
playback—discs rotate at a high speed and
may be damaged.
• Unplugging the unit before Good Bye
disappears from the display may cause
the system to return to the factory
settings.
NS03_ZFL.book 80 ページ ２００３年７月３１日 木曜日 午後７時０分