Panasonic DMC-LZ7 - Manual (Page 93)

Others
93
VQT1C60
[USB MODE CHANGED. PLEASE
REMOVE THE USB CABLE.]
This message will be displayed if you
change the mode dial to a mode other than
print mode [
] while this unit and the
printer are connected.
Set the mode dial to [
] again and then
disconnect the USB connection cable. If
printing, stop the printing and then
disconnect the USB connection cable.
Troubleshooting
If you return the menu settings to the initial
settings at the time of purchase, the
condition may improve.
Select [RESET] in the [SETUP] menu.
(P20)
∫ Batteries and the power source
1: The camera turns off immediately
even when battery power is full.
The remaining battery power is low
even if new batteries are inserted.
• The remaining battery power may not
be displayed accurately, and the
camera may suddenly stop working,
when the type of battery and the
settings on [BATTERY TYPE] are not
identical. However this is not a
malfunction. Depending on the battery
brand and the operating temperature, or
if exhausted batteries are used, the
remaining battery power may not be
displayed accurately.
– Please check [BATTERY TYPE] (P18)
in the [SETUP] menu.
2: The camera cannot be operated even
when it is turned on.
• Are the batteries inserted correctly?
• Use sufficiently charged batteries when
using Ni-MH batteries.
3: The LCD monitor turns off while the
camera is turned on.
• Is power save mode (P19) or economy
mode (P19) activated?
– Press the shutter button halfway to
cancel these modes.
• Are the batteries exhausted?
– Replace them with batteries which
have sufficient capacity. (When you
use Ni-MH batteries, charge them.)
4: The camera turns off immediately
after it is turned on.
• Are the batteries exhausted?
– Replace them with batteries which
have sufficient capacity. (When you
use Ni-MH batteries, charge them.)
– If you leave the camera on, the batteries
will be exhausted. Turn the camera off
frequently by using power save mode
(P19), economy mode (P19), etc.
∫ Recording
1: The picture cannot be recorded.
• Is the mode dial correctly set?
• Is there any memory remaining on the
built-in memory or the card?
– Before recording, delete some
pictures. (P30)
2: The recorded picture is whitish.
The lens is dirty.
• The picture can become whitish if there
is dirt e.g. fingerprints on the lens. If the
lens is dirty, turn on the camera, eject
the lens barrel (P7) and gently wipe the
lens surface with a soft dry cloth.
3: The recorded picture is too bright or
dark.
• Check that the exposure is correctly
compensated. (P40)
4: 2 or 3 pictures are taken at one time.
• Is [BURST] in the [REC] mode menu
set to [ON]? (P61)
5: The subject is not focused properly.
• The focus range varies depending on
the recording mode.
Rotate the mode dial to set the proper
mode for the distance to the subject.
VQT1C60ENG.book 93 ページ ２００７年１月１１日 木曜日 午後６時４９分