Panasonic AJ-HDP2000P - Manual (Page 17)

17
Rack Mounting
The unit can be installed in a 19-inch standard rack using the rack-mount adaptors supplied with the unit.
We recommend using the slide rails and brackets specified below for the installation.
CC3001-99-0191 slide rails and B-308 brackets are made by CHASSIS TRAK.
For further details, consult your dealer.
1
Remove the four feet from the unit’s bottom panel.
zTake care to avoid exposing the unit to vibration
or impact.
2
Mount the slide rail inner members onto the unit.
zThe length of the mounting screws is limited.
Use the screws (M4 a10) provided with the slide
rails.
If one or more mounting screws are lost or
misplaced, use screws less than 10 mm long.
zBe sure to fully tighten the inner members in the four
places on the left and right.
3
Attach the outer members of the slide rails and
the brackets to the rack.
Note
Check that the height is the same on the left and
the right.
4
Attach the rack-mount adaptors supplied with the
unit to the unit.
zUse the screws provided with the rack-mount
adaptors as the mounting screws.
zBe sure to fully tighten the rack-mount adaptors in
the two places on the left and the right sides.
5
Remove the stoppers of the inner members, and
install the unit in the rack.
After installation, check that the unit moves
smoothly.
zKeep the temperature in the rack between 5°C
(41°F) and 40°C (104°F)
zUse the rack-mount angular brackets supplied with
the unit.