Connector section (rear), Controls and their functions (continued) – Panasonic AJ-HDP2000P User Manual
Page 7
7
Controls and their Functions (Continued)
2. Connector Section (Rear)
!1" AC Input Socket
Use the accessory power cord to connect the socket to the power outlet
!2" Fuse
Power circuit fuse
!3" GND (ground) Terminal
When connected with another unit, the unit must be ground here
!4" Dual-Link SDI Input
For inputting the Dual-Link digital signals
!5" Dual-Link SDI Output 1, 2
For outputting the Dual-Link or HD digital signals
(4:4:4/4:2:2 switchable)
!6" HD-SDI Monitor Output
For outputting the HD digital signals (4:2:2 samples)
!7" Serial Data input (HD-SDI)
This is connected to the HD SDI OUT connector on the HD-D5 VTR for
inputting for video/ audio/ tc output data from the HD-D5 VTR.
!8" Serial Data Output (HD-SDI)
This is connected to the HD SDI IN connector on the HD-D5 VTR for
outputting the video/ audio/ tc data.
!9" HD SYNC OUT
This is connected to the REF IN HD connector on the HD-D5 VTR.
The sync signal re-generated from the HD REF IN signal of the
processor.
!10" HD REF IN
For inputting the tri-level sync signals as reference signals
!11" HD Reference Through Output
(Auto Terminated)
This is through output of input reference signal
!12" Service Switch
(only Use Service Maintenance)
This slide switch is used only in service mode.
Please Slide OFF for Normal Operation.
!13" SERVICE ONLY (RS-232C)
<15pin>
(only Use Service Maintenance)
This connector is used only in service mode.
!9"
!8"
!7"
!6"
!2"
!11"
!13"!12" !10"
!1" !3"
!4" !5"