Remove the front grille, Condensed water drainage – Panasonic CW-A121VR User Manual

Page 5

Advertising
background image

8.3.2.

Remove the Front Grille.

• Remove the front intake grille

Pull up the front intake grille about 90° and slide it slightly to
the left to unhook the tabs.

Caution: Do not raise the front intake grille anyhigher than
90°to the unit or damage to the tabs may occur.
• Remove the air filter.

Tilt up and pull out the air filter by holder.

• Remove the front grille.

1. At bottom right side of the front grille, press inward on

cabinet near the power cord, and pull the grille outward
to the right until right tab releases.

2. At bottom left side, push inward on cabinet and pull the

grille outward to the left to release the left tab. Do not
pull the bottom edge toward you more than 7.62cm to
prevent two top tabs from damage.

3. Slide the front grille upwards to free the two top tabs

from slots at the top of the cabinet.

8.3.3.

Condensed water drainage

In order to drain off the condensed water, it is recommended
that you install a drain pan using the following procedure.
• Slide the chassis out from the cabinet.

• Install the drain pan.

Install the drain pan at the left corner of the cabinet using 2
screws.
• Connect a drain hose. Fit the drain hose to the drain pan.

NOTE: Drain hose or tubing can be purchased locally to satisfy
your particular needs.
• Slide the chassis back into the cabinet. Reinstall the cabinet

to the chassis by using screws.

12

CW-A121VR

Advertising