Pride Mobility Legend 3-Wheel Scooter - Manual (Page 13)

22 23 Legend www.pridemobility.com www.pridemobility.com Legend
V . Y O U R S C O O T E R
Charger Power Cord Receptacle
The charger power cord plugs into your scooter’s battery charger by means of the charger power cord receptacle.
Ammeter
During charging, the ammeter indicates the charging rate, or how hard the charger is working to charge the Legend’s
batteries. See VI. “Batteries and Charging.”
Main Circuit Breaker (Reset Button)
When the voltage in your scooter’s batteries becomes low or the scooter is heavily strained because of excessive
loads or steep inclines, the main circuit breaker may trip to protect the motor and electronics from damage. See
figure 6.
! The main circuit breaker reset button pops out when the breaker trips.
! When the breaker trips, the entire electrical system of your scooter shuts down.
! Allow a minute or two for your scooter’s electronics to “rest.”
! Push in the reset button to reset the main circuit breaker.
! If the main circuit breaker trips frequently, you may need to charge your batteries more often. You may also
need to have your authorized Pride Provider perform a load test on your scooter’s batteries.
! If the main circuit breaker trips repeatedly, see your authorized Pride Provider for service.
REAR SECTION
The onboard battery charger (not shown), the charger power cord receptacle, the batteries (not shown), the main
circuit breaker reset button, the ammeter, the manual freewheel lever, the anti-tip wheels, and the motor/transaxle
assembly are located on the rear section of your scooter. See figure 6.
Figure 6. Rear Section
CHARGER POWER CORD RECEPTACLE
AMMETER
MAIN CIRCUIT BREAKER
(RESET BUTTON)
ANTI-TIP WHEEL ANTI-TIP WHEEL
MANUAL FREEWHEEL LEVER
MOTOR/TRANSAXLE
ASSEMBLY
3-AMP REAR LIGHTS FUSE
3-AMP REAR TURN SIGNALS FUSE
5-AMP SPARE FUSE
5-AMP CHARGER FUSE
V . Y O U R S C O O T E R
Running Lights Switch
This switch controls your scooter’s front (upper) and rear running lights.
! Toggle the switch forward to turn on your scooter’s running lights.
! Toggle the switch back to turn off your scooter’s running lights.
Headlight Switch
This switch controls your scooter’s front (lower) light.
! Toggle the switch forward to turn on your scooter’s front lower light.
! Toggle the switch back to turn off the light.
Horn Buttons
These buttons activates a warning horn. Your scooter must be turned on for the horn to be operational. Do not
hesitate to use the warning horn when doing so may prevent accident or injury.
Hazard Lights Switch
This switch activates the 4-way flashers on your scooter.
! Toggle the switch forward to turn on the flashers.
! Toggle the switch back to turn off the flashers.
Turn Signal Buttons
! Press the appropriate turn signal button once to activate it.
! Your scooter’s turn signals are timed to shut off automatically.
3-Amp Tiller Console Fuses
These fuses help protect your scooter’s front lighting, turn signals, and key switch console systems from receiving
an overload of electrical current. The fuses used in your scooter are the same type used in automobiles. See XI.
“Care and Maintenance” for fuse replacement.
3-AMP LEFT TURN SIGNAL FUSE
3-AMP RIGHT TURN SIGNAL FUSE
3-AMP LOWER LIGHT FUSE
3-AMP KEY SWITCH FUSE
SPARE
Figure 5A. Tiller Console Fuses