Pride Mobility Legend 3-Wheel Scooter - Manual (Page 20)

36 37 Legend www.pridemobility.com www.pridemobility.com Legend
I X . D I S A S S E M B LY A N D A S S E M B LY
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 23.
2. Align the lower slots of the front section with the cor-
responding pegs on the front of the rear section.
3. Holding the seat post, slowly pivot the rear section
forward until the curved locking brackets are fully con-
nected onto the top rear pegs. See figure 24.
4. Raise the tiller.
5. Secure the toggle latch. See figure 19.
! Lower the toggle latch buckle.
! Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear harness and both battery
harnesses.
7. Replace the shroud.
8. Replace the seat and secure it into place.
WARNING! Position the front-to-rear
harness cable so it won’t become
pinched between the frame halves
when pivoting the rear
section forward. See figure 24.
Figure 23. Frame Sections
Figure 24. Frame Lockup
FRONT-TO-REAR HARNESS
I X . D I S A S S E M B LY A N D A S S E M B LY
6. Unplug both black and white 2-pin battery harnesses. See figure 17.
7. Unplug the front-to-rear harness. See figure 18.
Toggle Latch Release
1. Push in the toggle latch release button while pulling back the toggle latch. See figure 19.
2. Position the toggle latch buckle over the top of the toggle latch. See figure 20.
3. Lower the tiller to the scooter floorboard.
Figure 20. Toggle Latch (Unlatched)
TOGGLE
LATCH TOGGLE
LATCH
RELEASE
BUTTON
Figure 19. Toggle Latch (Latched)
TOGGLE
LATCH
BUCKLE
Frame Separation
1. Push back on the seat post to pivot the scooter’s rear section backwards until the rear section is standing
vertically on its rear bumper. See figure 21.
2. Lift the front section up until the lower pegs are no longer in the slots. See figure 22.
3. Carefully move the front section away from the rear section.
Figure 21. Frame Positioning Figure 22. Separating The Frame Sections
WARNING! Failure to unplug both battery harnesses and the front-to-rear harness prior to
separating the front and rear sections could result in permanent damage to the scooter.
Figure 18. Front-To-Rear Harness Figure 17. Battery Harnesses