Printek Mobile Thermal MtP400 - Manual (Page 28)

Printer Configuration
Present Distance Present Distance
0.0000”
Possible Values: 0.0000”* …1.2911”
This feature sets the distance the paper is moved forward after the black mark is sensed. When the black mark
is sensed, the paper will be fed forward by this amount to allow for tearing or peeling of a label. When the next
print job begins, the paper will be reverse fed this same amount before printing begins.
When the Tear to Mark Distance is a negative value, this is typically set to the inverse of that value.
Interface Menu
INTERFACE MENU
Current Host I/O
After entering Setup as described earlier in “Setup Basics”, press the Advance Button until “INTERFACE
MENU
” is displayed on the top line.
The bottom line displays the currently selected host interface. The Interface Menu provides access to the
features that may be configured for the currently selected interface.
Note that the Serial interface is standard in all MtP400 series printers. If another, optional interface such as
IrDA, Bluetooth, or Wi-Fi is installed, you may select between the Serial interface and the optional interface by
pressing the Arrow Button. Once the desired interface is displayed, you may do one of the following:
press the Enter Button to review and/or change the features related to the selected interface, or
press the Advance Button to advance to the OPTIONS MENU
Pressing the Enter Button will advance through the following features for the selected Interface in the order
listed below.
Please refer to “Interfacing To A Host Computer” on page 33 for additional information.
Serial Interface
INTERFACE MENU
Serial
Note that “Serial” must be displayed on the bottom line of the display in order to access the following
features and for this interface to be active when Setup is exited.
22