Printek Mobile Thermal MtP400 - Manual (Page 38)

Printer Configuration
Print Promotion Print Promo
No
Possible Values: No*, Yes
This feature is only available in firmware version 2.8 or later.
When set to “Yes” this feature causes a previously stored graphic image with an ID value of “$” to be printed at
the end of each print job.
This feature may be used to print a special logo or graphic image of a special sales promotion or other event,
that also needs to be enabled/disabled by the user in the field.
Note: In firmware version 2.9 and later, multiple graphic images may be stored with the ID values of “!”,
“@”, “#”, “$”, “%”, “^”, “&”, “*”, “(“, and/or “)”. In this case, the printer will automatically cycle
through each of these images printing one at the end of each print job.
Please refer to the MtP Series & FieldPro Programmer’s Manual for more information on storing graphics and
logos.
32