Protec Protech Compact2 Film Processor SX 2 - Manual (Page 57)

COMPACT 2 TM 57
COMPACT 2 NDT
English
®
Order No. 1193 - X - Y000
The Film Processor Compact 2 series was extended by a further version.
Introduction
Processing time and developer temperature of the Compact 2 NDT processor have
been adjusted to the requirements of NDT-films. This results in the following modi-
fications compared with the Compact 2 standard processor.
General
To maintain constantly good film quality the NDT-roller (upper roller of first roller
pair of fixer rack) has to be changed every 3 - 6 months, depending on the quantity
of films processed, the chemicals and films used. Three replacement rollers are de-
livered together with each machine. These rollers are subject to wear and tear and
therefore excluded from the warranty!
Technical Specifications (compare page 4 )
Processing time (compare page 14 )
Processing time from 2 - 10 min
Developer temperature (compare page 14 )
Developer temperature from 26 - 40 °C
X: 1 50 Hz Y: 0 Open working table
2 60 Hz 7 Closed base
Important!
Please take care that the film does not carry any dirt into the
processor.
Processing capactiy: 174 films 24x30 cm (crosswise), at lowest
processing time
Process time: 2 - 10 min
Linear speed: 15.5 - 76.5 cm/min
Developing time:
28 - 142 s
Developer temperature 26 - 40 °C
Processing and developer time relation
Processing time (min) Developer time (s) Infeed speed (cm/min)
2,0 28 76
2,5 35 61
3,0 42 51
3,5 49 45
4,0 57 38
4,5 64 34
5,0 71 31
5,5 77,5 28
6,0 84 25,5
6,5 91 24
7,0 98 22,5
7,5 106 21
8,0 114 19
8,5 121 18
9,0 128 17
9,5 135 16
10,0 142 15,5