Pride Mobility Removable Battery Pack SilverStar - Manual (Page 15)

Basic Operation Instructions 15
www.silverstarmobility.com Removable Battery Pack
TROUBLESHOOTING
Any electromechanical device occasionally requires some troubleshooting.
However, most of the problems that may arise can usually be solved with a
bit of thought and common sense. Many of these problems occur because
the battery is not fully charged or because the battery is worn down and can
no longer hold a charge.
What if the battery will not charge?
„ Fully insert the appropriate ends of the charger cord into their ports.
„ Ensure the battery pack is inserted properly into the charger pack.
„ Check the fuses located on the bottom of the battery pack.
„ Check the fuse located in the auxiliary outlet plug.
In the event the batteries do not charge when using an auxiliary outlet:
1. Insert the auxiliary outlet plug into the auxiliary power outlet or cigarette
lighter outlet.
2. If the LED on the auxiliary outlet plug does not light up, change its fuse.
To change the fuse in the auxiliary outlet plug:
1. Twist the end of the auxiliary outlet plug until it seperates from the pri-
mary outlet plug.
2. Remove the end of the cap, taking care to retain the silver charging connector.
3. Remove the fuse by pulling it out of its slot.
4. Examine the fuse to be sure it is blown. See figures 10 and 11.
5. Insert a new fuse of the proper rating.
6. With the silver charging connector in place, twist the end of the cap un-
til it is secure.
Figure 10. Working Fuse Figure 11. Blown Fuse (Replace)