Pride Mobility Removable Battery Pack SilverStar - Manual (Page 9)

Basic Operation Instructions 9
www.silverstarmobility.com Removable Battery Pack
Figure 3A. Harness Connections
MOUNTING SCREWS
Figure 3. Battery Pack Installation
BATTERY
HARNESS
PROHIBITED! Do not mount the battery pack in an area
where it will be affected by moisture or dirt.
Follow these steps to install the battery pack to the SilverBoom:
1. Determine a location to mount the battery pack to the vehicle. See
figure 3.
2. Inspect the undercarriage of the vehicle (where the battery pack is lo-
cated) for obstructions that may hinder the installation of the mounting
screws that secure the base to the vehicle (e.g., electrical wiring, the gas
tank, bumper mounts, or exhaust pipes).
3. Mark the location of the mounting holes, then drill pilot holes, which
should be smaller than the diameter of the mounting screws.
4. Secure the case to the vehicle using the supplied hardware.
5. Plug the harness from the battery pack into the mating harness extending
from the lift. See figure 3A.
WARNING! A battery pack that is not secured properly to
the vehicle can become a hazard while driving.