Panasonic WR-XS3P - Manual (Page 25)

25
■ Recording and Playback with One Deck
To record and play back a broadcast with one deck, connect the SUB OUTPUT jack to cut the feedback.
Then set the DIP switch associated with the MULTI INPUT ST jacks to OFF.
Note: Use the cable shown in the figure to connect the unit SUB OUT and the deck's REC OUT.
To output either mono or stereo signal through REC OUT
The stereo and mono recording input signals are usually mixed through the REC OUT jack.
The internal switch setting is necessary if you want to output either of them.
Refer to a service manual procurable in your area.
Recording and playback deck
PLAY
REC
SUB OUTPUT STEREO INPUT 1 to 4
Ser No.
0dB is referenced to 0.775Vrms AC IN SIGNAL GND
1 2 3 4 1
L
R
3 4 ST AUTO MUTE
3 4 ST AUTO MUTE
MONO INPUT –60dB to –10dB 10k Ω INPUT –10dBV 10k Ω STEREO STEREO
PIN CONNECTION
MONO
INPUT
MODE
1
2
3
A
ON
OFF ON
No. 1: GND
No. 2: HOT
No. 3: COLD
OFF
4 3 2 1 4 3 2 1
MODE SELECT
SELECT STEREO MONO
SUB
MONO ST
MULTI INPUT SUB IN REC OUT
–10dBV 10k Ω +4dB 10k Ω –10dBV 10k Ω –45dB 10k Ω
2 3 4
L
R
L
L R
R
OUTPUT +4dB 10k Ω
B
The unit's
SUB OUT
The deck's
REC IN
Tip-ring-sleeve (TRS)
phone plug (STEREO)
RCA pin plug