Panasonic WR-XS3P - Manual (Page 9)

9
!0 Input peak indicator [INPUT PEAK]
Lights up when any input signal reaches –3 dB (from
the MONO INPUT 1 to 4 connectors, the STEREO
INPUT 1 to 4 jacks , the MULTI INPUT ST connectors,
the MULTI INPUT MONO connector and the LINE IN
jack) above the clip level.
!1 Output level knobs
[STEREO OUT]
Turning to the left will lower the stereo output level.
Turning to the right will raise the output level.
q DIP switches
Switches A and B select the unit mode from among
mode 1, 2 and 3.
Switches MONO 1 to 4 and STEREO 1 to 4 assign any
input lines to SUB OUTPUT jack.
Refer to pp. 15 to 18.
w Stereo input auto mute switch [ST 1- 4 AUTO MUTE]
Selects the auto mute setting when an input signal is
accepted via the MONO INPUT connector 1 or 2. Auto
mute is applicable to information broadcasting with
BGM in a shop.
ON ( ; ): The volume(s) of the STEREO INPUT 1 to 4
jacks are automatically muted.
OFF ( l ): The volume(s) of the STEREO INPUT 1 to 4
jacks are not automatically muted.
Mute level: 9 dB
e Sub output jack [SUB OUTPUT]
Transmits a signal from a desired input line (from
among the STEREO INPUT 1 to 4 jacks, the MONO
INPUT 1 to 4 connectors, or the MULTI INPUT ST jacks)
which is mixed by the unit.
Mono: 1 circuit
Output jack: TRS jack electronic balanced
Output level: +4 dB
Impedance: 10 k
Ω
r Mono output jack [MONO OUTPUT]
Transmits a mono signal mixed by the unit.
Mono: 1 circuit
Output jack: TRS jack electronic balanced
Ser No.
0dB is referenced to 0.775Vrms
AC IN SIGNAL
GND
1 2 3 4 1
L
R
1 4 ST AUTO MUTE
1 4 ST AUTO MUTE
MONO INPUT –60dB to –10dB 10k Ω INPUT –10dBV 10k Ω STEREO
STEREO
PIN CONNECTION
MONO
INPUT
MODE
1
2
3
A
ON
OFF ON
No. 1: GND
No. 2: HOT
No. 3: COLD
OFF
4 3 2 1 4 3 2 1
MODE
SELECT
SELECT
STEREO MONO
SUB
MONO ST
MULTI INPUT SUB IN REC OUT
–10dBV 10k Ω +4dB 10k Ω –10dBV 10k Ω –45dB 10k Ω
2 3 4
L
R
L
L R
R
OUTPUT +4dB 10k Ω
B
q
e r t
w y u i o !0 !1 !2
!3
■ Rear View
[MONO OUT]
Turning to the left will lower the mono output level.
Turning to the right will raise the mono output level.
[SUB OUT]
Turning to the left will lower the sub output level.
Turning to the right will raise the output level.
Output level: +4 dB
Impedance: 10 k
Ω
t Stereo output jacks [STEREO OUTPUT L/R]
These jacks transmit a stereo signal mixed by the unit.
Stereo: 1 circuit
Output jack: TRS jack electronic balanced
Output level: +4 dB
Impedance: 10 k
Ω
y Recording output jacks [REC OUT L/R]
These jacks connect to a recording device such as a
stereo cassette recorder or MD recorder.
Stereo: 1 circuit
Output jack: RCA type pin jack unbalanced
Output level: –10 dBV
Impedance: 10 k
Ω
u Sub input jacks [SUB IN L/R]
These jacks receive output signals from sub mixer, etc.
The signals input to these connectors are output
through the STEREO OUTPUT jack.
Stereo: 1 circuit
Input jack: RCA type pin jack unbalanced
Input level: +4 dB
Impedance: 10 k
Ω
i Multiple stereo input jacks [MULTI INPUT ST L/R]
These jacks connect to audio-visual devices such as a
CD player and tape recorder.
Stereo: 1 circuit
Input jack: RCA type pin jack unbalanced