Pioneer DEH-P80RS - Manual (Page 15)

Black plate (15,1)
Listening to the radio
6 6 6
1 1 1 1 2 2 2 2 3 3 3 3 5 5 5 5 4 4 4
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
Important
If you are using this unit in North, Central or
South America, reset the AM tuning step (see
Setting the AM tuning step on page 64).
1 Band indicator
Shows which band the radio is tuned to, AM
or FM.
2 Stereo ( 5) indicator
Shows when the selected frequency is
being broadcast in stereo.
3 Preset number indicator
Shows which preset has been selected.
4 LOC indicator
Shows when local seek tuning is on.
5 Signal level indicator
Shows the radio wave strength.
6 Frequency indicator
Shows the frequency to which the tuner is
tuned.
1 Press SOURCE to select the tuner.
Press SOURCE until you see Tuner displayed.
2 Press BAND to select a band.
Press BAND until the desired band (FM-1,
FM-2, FM-3 for FM or AM) is displayed.
3 To perform manual tuning, push
MULTI-CONTROL left or right.
The frequencies move up or down step by
step.
4 To perform seek tuning, push and hold
MULTI-CONTROL left or right for about one
second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pushing
MULTI-CONTROL left or right.
# If you push and hold MULTI-CONTROL left or
right you can skip stations. Seek tuning starts as
soon as you release
MULTI-CONTROL.
<CRD4082-A/N>15
Tuner
En
15
English
Section
04