Pioneer DEH-P80RS - Manual (Page 58)

Black plate (58,1)
Recalling equalizer curves
The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display Equalizer curve
Powerful Powerful
Natural Natural
Vocal Vocal
Flat Flat
Custom 1 Custom 1
Custom 2 Custom 2
Super Bass Super bass
! Custom 1 and Custom 2 are adjusted
equalizer curves that you create. Adjust-
ments can be made with a 16-band graphic
equalizer.
! When Flat is selected no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
Flat and a set equalizer curve.
% Press EQ to select the equalizer.
Press
EQ repeatedly to switch between the fol-
lowing equalizers:
Super Bass
—Powerful—Natural—Vocal—
Flat —Custom 1—Custom 2
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of
Flat, can be adjusted to a fine de-
gree (nuance control).
1 Use MULTI-CONTROL to select EQ 1.
EQ 1 appears in the display.
2 Push MULTI-CONTROL left or right to
select an equalizer curve.
3 Push MULTI-CONTROL up or down to
adjust the equalizer curve.
Each time
MULTI-CONTROL is pushed up or
down, the equalizer curve increases or de-
creases respectively.
+6 to
–6 is displayed as the equalizer curve is
increased or decreased.
# The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
# The equalizer curve with all frequencies set to
0 cannot be adjusted.
Adjusting 16-band graphic
equalizer
For Custom 1 and Custom 2 equalizer curves,
you can adjust the level of each band.
! A separate Custom 1 curve can be created
for each source. (The built-in CD player and
the multi-CD player are set to the same
equalizer adjustment setting automati-
cally.) If you make adjustments when a
curve other than
Custom 2 is selected, the
equalizer curve settings will be memorized
in
Custom 1.
! A Custom 2 curve can be created common
to all sources. If you make adjustments
when the
Custom 2 curve is selected, the
Custom 2 curve will be updated.
1 Recall the equalizer curve you want to
adjust.
See Recalling equalizer curves on this page.
2 Use MULTI-CONTROL to select EQ 2.
EQ 2 appears in the display.
<CRD4082-A/N>58
Audio Adjustments
En
58
Section
11