Panasonic TQBH9003-6 - Manual (Page 30)

$
%
30
Starting to use
Turning on the power
Please ensure that all preparations have been completed before turning on
the power. (Refer to pages
24 – 29 .)
POWER
RGB
VIDEO
LASER
MENU
PAGE
SETUP
AUTO RGB VIDEO AUTO SETUP
ON(G)
STANDBY(R)
ENTER MENU
POWER SHUTTER
INPUT
TEMP LAMP RGB INPUT
– FOCUS +
– ZOOM +
POWER
RGB
VIDEO
LASER
MENU
PAGE
SETUP AUTO RGB VIDEO AUTO SETUP
ON(G)
STANDBY(R)
ENTER MENU
POWER SHUTTER
INPUT
TEMP LAMP RGB INPUT
– FOCUS +
– ZOOM +
POWER
RGB
VIDEO
LASER
MENU
PAGE
SETUP
AUTO
RGB VIDEO AUTO SETUP
ON(G)
STANDBY(R)
ENTER MENU
POWER SHUTTER
INPUT
TEMP LAMP RGB INPUT
– FOCUS +
– ZOOM +
# Remove the lens cover.
$ Connect the accessory power cord.
% Press the MAIN POWER switch to
the “l” side to turn on the power.
The power indicator on the projector
will illuminate red.
& Press the POWER button.
The power indicator on the projector
will flash green. After a short period,
the indicator will illuminate green, and
a picture will be projected.
' Press the input select (RGB, VIDEO)
button to select the input signal.
The input signal selected will change
as shown at below each time an input
select button is pressed.
( While pressing the adjuster buttons,
adjust the forward/back angle of tilt
of the projector.
To make fine adjustments to the angle of
tilt of the projector, turn the front
adjustable legs. (The front adjustable legs
will be locked if they are fully extended
and then turned anticlockwise. Turn them
back clockwise to release the lock.)
RGB VIDEO
S-VIDEO
VIDEO
RGB VIDEO
SD CARD
NETWORK
DVI
RGB3
RGB2
RGB1
) Press the AUTO SETUP button to
initiate automatic positioning.
The automatic positioning is only for vertical
keystone distortion. To correct the
horizontal keystone distortion or when
keystone distortion has not been corrected
to the optimum level, carry out the keystone
correction as described on page
42 .