Panasonic TQBH9003-6 - Manual (Page 90)

90
Fitting and removal of SD
card and wireless card
SD card
Removal
q q Open the slot cover
w
w Confirm that the access
lamp is not blinking (i.e., SD
card is not under reading or
writing operation) at the
right back of the slot.
Note:
• Be sure to confirm that the access
lamp is not blinking when to remove
the card. Removing the SD card while
the access lamp is blinking may
destroy the data stored on the card.
e e Press the center of the SD
card to release the lock and
remove the card
r r Close the slot cover
Fitting
Pay attention to the difference between
up and down sides of the SD card.
q q Open the slot cover
w w Insert the SD card
With the card label facing up, insert
the card from the side that has a cut
corner until it reaches the depth and
is locked.
Note:
• Forcible insertion of the SD card in a
wrong direction may cause a fault.
e e Close the slot cover.
Access lamp