Patton electronic G.SHDSL INTEGRATED 3086 User Manual
Model 3086 g.shdsl integrated access device, User guide
Advertising
Model 3086
G.SHDSL Integrated
Access Device
User Guide
Sales Office:
+1 (301) 975-1000
Technical Support:
+1 (301) 975-1007
E-mail:
WWW:
www.patton.com
Part Number: 07M3086, Rev. E
Revised: February 16, 2012
Important
This is a Class A device and is intended for use in a light industrial environment. It is not intended nor approved for use in an industrial
or residential environment.
Start Installation
For Quick
see page 27
Advertising
Table of contents
Document Outline
- Contents
- About this guide
- Chapter 1 General Information
- Chapter 2 Product Overview
- Chapter 3 Quick Start Installation
- Chapter 4 Basic Application Configurations
- Introduction
- TDM Port
- V.35 and X.21 Ports
- T1 Interface
- E1 Interface
- Using the 3086 as a simple modem (TDM data over DSL)
- TDM Plus Ethernet Traffic
- Using the 3086 in Routed or Bridged applications
- DSLAM Connections with remote CPE units
- Chapter 5 Specialized Configurations
- Chapter 6 Security
- Chapter 7 NAT (Network Address Translation)
- Chapter 8 Monitoring Status
- Chapter 9 Diagnostics
- Chapter 10 Contacting Patton for assistance
- Appendix A Compliance information
- Appendix B Specifications
- General Characteristics
- G.SHDSL Characteristics
- Ethernet
- Sync Serial Interface
- T1/E1 Interface (3086/RIK and RIT models only)
- 64K/G.703 Port (3086/RIF Model)
- Protocol Support
- PPP Support
- ATM Protocols
- Management
- Security
- Compliance Standard Requirements
- Dimensions
- Power and Power Supply Specifications
- Appendix C Cable Recommendations
- Appendix D Physical Connectors
- Appendix E Command Line Interface (CLI) Operation
- Appendix F Interworking Functions Information
- Introduction
- Frame Relay Local Management Interface
- LMI Configuration Options:
- managementType: (Default Value: no_maintenance)
- MgtState
- mgtAutoStart: (Default Value: FALSE)
- T391_Value: (Default Value: 10)
- T392_Value: (Default Value: 16)
- fullReportCycle: (Default Value: 6)
- netErrorWindowSize: (Default Value: 4)
- netMaxErrors: (Default Value: 3)
- userErrorWindowSize: (Default Value: 4)
- userMaxErrors: (Default Value: 3)
- CLI Configuration Methods
- Web Configuration Methods
- LMI Configuration Options:
- Frame Relay Service Interworking (FRF.8)
- Frame Relay Network Interworking (FRF.5)
- Frame Relay (Ethernet Based) Operations
- Serial Interface Configuration
- Ping and Trace Route
- Backup and Restore Features