Panasonic SLV-SE700B - Manual (Page 74)

74 Searching using the Acces Smart function
Tips
• You can store information for up to 24 programmes on a single list.
• While recording, you can display the ACCES SMART screen using the ACCES SMART
button. If you decide to stop recording, press ACCES SMART to make the ACCES SMART
screen disappear first. Then press x STOP.
Notes
• You cannot use this function unless the clock is set.
• Depending on the tape, the total or remaining time may not appear correctly.
• If many short programmes are recorded on a tape, multiple programmes may be included in a
single block. In this case, only the latest programme information will appear in the ACCES
SMART screen.
• Blank time is measured from the end of the last recorded programme to the end of the tape.
However, if you eject the tape and then make a new recording on the same tape, the original
recorded programme(s) is displayed as a blank space.
• If no information is stored in the VCR’s memory, DONNEES RECENTES does not appear in
the ACCES SMART screen.
• The station name* may not appear if the VCR does not receive station name information
signals.
• If you start recording a programme “D” from the middle of a previously recorded programme
“A” and into another previously recorded programme “B,” the Acces Smart information for
the second programme “B,” which is recorded over, is deleted.
* not available on SLV-SE600B
3 Press M/m to highlight DONNEES RECENTES.
If you want to reset the latest data screen,
highlight PAS DES DONNEES and press OK,
then record a programme.
4 Press OK.
The latest data stored in the VCR’s memory is displayed.
DATE HEURE PROG.
:
:
OK REGLER
SELECTIONNER
PAS DE DONNEES
DONNEES RECENTES
1 4 : 0 0 1 5 : 0 0 FGH
0
2 9 . 9
. 9 3
1 9 : 0 0 2 0 : 0 0 3 2 8 . 9 5
2 0 : 0 0 2 1 : 0 0 AAB
6 : 3 0 7 : 0 0 1 . 1 0
ACCES SMART :
ACCES SMART
SORTIE
I J K
Originally recorded programmes
A B
Recording the programme “D” over the programme “A” and “B”
C
A D C