Panasonic SLV-SE700B - Manual (Page 77)

77 Adjusting the picture
Ad
di
tiona
l O
p
era
tions
To deactivate the OPC function
Set OPC to NON in the OPTIONS-1 menu. The OPC indicator in the display
window turns off.
Tip
• To set tracking to the centre position, press the ALIGNEMENT + and – buttons at the same
time.
Notes
• You can adjust the tracking for an NTSC-recorded tape but the tracking meter won’t be
displayed.
• With the Auto Long Play function on, the OPC function will work only in SP mode. If the
tape speed automatically switches from SP to LP, the OPC function turns off. If, however, the
entire programme is recorded in LP mode, the OPC function will work.
• There is a delay of about ten seconds before the VCR actually starts recording while the VCR
analyses the tape. To avoid the delay, first set the VCR to recording pause (the OPC indicator
flashes slowly) and press z ENR to have the VCR analyse the tape (the OPC indicator
flashes rapidly) and return to recording pause. After the OPC indicator stops flashing, press
X PAUSE to start recording immediately.
If you want to start recording quickly without using the OPC function, first set the VCR to
recording pause (the OPC indicator flashes slowly) and press X PAUSE again to start
recording.