Pioneer VSX-9110TXV-K - Manual (Page 68)

Controlling the rest of your system 11
68
En
6 If necessary, press the input source button for the
component whose command you want to input.
This is only necessary if the command is for a new
component (input source).
7 Select the button for the command you want to
input.
The following remote control commands can be
selected:
• You don't need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components , you don’t need to:
• program the power to switch off in a shutdown
sequence (except DVD recorders);
• program the power to switch on if it’s the source
component selected in step 3;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
8 Repeat steps 5–7 to program a sequence of up to
five commands.
9 When you’re finished, use / to select EDITEXIT
from the menu and press ENTER .
You will return to the remote control SETUP menu. Select
* EXIT * again to exit.
Using multi operations
You can start multi operations with the receiver switched
on, or in standby.
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press an input source button that has been set up
with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.
Using System off
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press SOURCE .
The command sequence you programmed will run, then
all Pioneer components will switch off
1
, followed by this
receiver.
XM RADIO ROOM 2 HDMI2 CD-R/TAPE
DVR 2 CD
ANALOG
ATT
MIDNIGHT/
LOUDNESS
VIDEO
SEL
DIMMER
SLEEP
SR+
+10 D.ACCESS
DIALOG E S.RETRIEVER
CLASS DISC
RECEIVER SOURCE
SYSTEM OFF
INPUT
SELECT
ENTER
TUNE
TUNE
ST ST
ENTER
TOP MENU
AV PARAMETER CH LEVEL
CATEGORY
T.EDIT DTV MENU
MENU
RETURN
GUIDE BAND
SETUP
TV DVR1 TV CTRL
iPod RECEIVER TUNER HDMI1
DVD
TV CONTROL
SHIFT
VOL
STEREO STATUS SIGNAL SEL
THX ADV.SURR
SBch
INPUT
SELECT TV CH
MPX
AUDIO
DISP
SUBTITLE
MULTI OPE STANDARD
PHASE S.DIRECT MCACC
REC DTV ON/OFF DTV INFO
MUTE
TV VOL
REC STOP JUKEBOX
HDD
CH CH
DVD
RECEIVER
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
RECEIVER
SHIFT
STEREO STATUS SIGNAL SEL
THX ADV.SURR
SBch
AUDIO
DISP
SUBTITLE
MULTI OPE STANDARD
PHASE S.DIRECT MCACC
HDD
CH CH
DVD
DVR 2 CD
AV PRE-PROGRAMMED AND LEARNING REMOTE CONTROL UNIT
RECEIVER SOURCE
SYSTEM OFF
INPUT
SELECT
TV DVR1 TV CTRL DVD
SHIFT
STEREO STATUS SIGNAL SEL
THX ADV.SURR
SBch
AUDIO
DISP
SUBTITLE
MULTI OPE STANDARD
PHASE S.DIRECT MCACC
HDD
CH CH
DVD
RECEIVER
VSX-9110TXV_KU.book.fm 68 ページ ２００６年４月４日 火曜日 午後５時１５分