Polaroid Polaview 110 User Manual
Page 22
Macintosh
connections
1
Unplug the Macintosh monitor cable from the computer.
2
Plug one end of the supplied VGA video cable into the
RGB IN 1 port on the projector. Attach the VGA end of the
Mac - VGA cable adapter to the other end of the VGA video
c a b l e .
3
Plug the Mac end of the Mac - VGA cable adapter into the
Macintosh video port.
4
Connect the audio source to the projector AUDIO IN 1 port.
Refer to Connecting computer audio later in this chapter.
Note:
If you are using a second computer video or audio
source, plug the output cables for these sources into the
RGB IN 2 and AUDIO IN 2 connectors.
Use your existing monitor cable to connect the projector to a
separate computer monitor, so you can use the projector
and monitor at the same time.
Note:
The projector only supports the Multi-Sync monitors
for Macintosh computers. Other monitors cannot be used.
5
Turn the projector on and press the STANDBY/ON key.
18 Detailed setup