Polaroid Polaview 110 - Manual (Page 26)

Connecting non-computer audio
The AUDIO ports allow you to connect stereo or monaural
audio from a composite video source to the projector.
For stereo audio, use the supplied AV cable.
1 Insert the red (right) and white (left) ends of the cable into the
AUDIO OUT ports of a composite video audio source.
2 Connect the other end of each cable to the projector AUDIO
IN ports.
Note: Although two COMPUTER AUDIO sources and two
other AUDIO sources may be connected simultaneously,
only one can be active. If computer video is selected, COM-
PUTER AUDIO is active. If NTSC/PAL/SECAM/S-VHS video is
being viewed, AUDIO is active.
If your audio source is monaural, connect it to the left AUDIO
p o r t .
Connecting the PC to the projector through the
CONTROL port
You can connect the projector to a computer through the
CONTROL port. You can then use the joystick on your
remote control as the computer system mouse (see U s i n g
the joystick in Chapter 3). Before you begin, make sure the
projector and computer power are on and that the cables are
securely connected.
Note: This CONTROL feature is only available for PCs.
22 Detailed setupDeta, 5 wta, 85