Panasonic AG-DV2000P - Manual (Page 27)

Playback VCR Recording VCR
Turn the power on. Turn the power on.
Set EDIT MODE to
PASSIVE.
Set EDIT CONTROL to
EDIT.
Controlling the Recording VCR
through the Playback VCR
Follow the procedure described below:
Connect the edit cable to the EDIT socket on both
the playback VCR and the recording VCR.
Use AV cables to connect the input sockets on the
recording VCR with the output sockets on the
playback VCR.
Connect two monitors, one to each of the VCRs, so
that the screens from both VCRs can both be seen.
Set EDIT CONTROL on both the playback VCR and
the recording VCR to EDIT.
Press INPUT SELECT on the playback VCR and
select a position to which a cable is not connected.
Set EDIT MODE on both VCRs as follows:
Playback VCR : PLAYER
Recording VCR : PASSIVE
Set the EDIT MODE to
RECORDER.
Set EDIT CONTROL to
EDIT.
Press INPUT SELECT so that DV IN is
selected.
When performing Audio Dubbing or AV Insert,
select A1 or A2.
Recording VCR Playback VCR
Notes:
When this connection is made, the recording VCR
cannot be controlled using the DV cable.
Although noise may appear on the screen, depending
on the connections, the noise has no effect on the
actual editing operations.
Audio Insert and AV Insert are not possible in this
configuration.
When performing editing with this connection, the
editing accuracy may be worse than when controlled
from the recording VCR.
27