Panasonic AG-DV2000P - Manual (Page 53)

Select the desired editing operation, and
then press OK.
To insert picture: Video Insert.
To insert sound: Audio Insert.
To insert picture and sound: AV Insert.
Press PLAYER and JOG/SHUTTLE.
The picture from the playback unit appears on the
screen.
Search for the edit start point on the
playback unit and press MARK IN.
Search for the edit end point on the
playback unit and press MARK OUT.
(Continued on next page)
AV Insert is not possible in the following cases:
When the tape in the recording VCR (this unit) is:
Recorded in 16bit audio mode;
Recorded in LP mode:
Blank, or contains a blank portion in the middle.
When INPUT SELECT is set to DV IN.
Notes on editing point setting
The Program Insert and Audio Dubbing functions require
the setting of only three editing points: the in and out points
on the playback unit and the in point on the recording unit,
or the in point on the playback unit and the in and out points
on the recording unit.
If both in and out points are set on both the playback unit
and the recording unit, and the times between the points do
not match, editing stops at the first out point that is reached.
In order to ensure that the editing operation is performed
properly, the editing points should be set at least 20
seconds after the beginning of the tape.
The editing operation may not be performed correctly if the
set duration of a program is less than 4 seconds.
On video equipment whose Time code display or tape
counter display does not show the frame value, the area
where the frame value is displayed appears as “00f” or it
remains blank.
With some units, the frame value may be displayed when
MARK IN or MARK OUT is pressed in steps 5 and 6 even if
the unit concerned does not show the frame value.
53