Panasonic AG-DV2000P - Manual (Page 41)

Press (STOP) on this unit to stop
editing.
To monitor the mixed signal after Audio
Mixing
Press STEREO SELECT during playback and select
STEREO2.
Notes:
Audio Mixing is not possible in the following cases:
When the tape in the recording VCR (this unit) is:
Recorded in 16bit audio mode;
Recorded in LP mode;
Blank, or contains a blank portion in the middle.
When INPUT SELECT is set to DV IN.
In order to ensure that the editing operation is performed
properly, the editing points should be set at least 20
seconds after the beginning of the tape.
When editing with a microphone
1. Connect the microphone to the MIC socket.
2. Press JOG/SHUTTLE.
3. Use Jog Dial and Shuttle Ring to search the recording
start point.
4. Press AUDIO DUB.
5. Press MIXING EDIT.
6. Use AUDIO REC LEVEL slider to adjust the microphone
level.
7. Press PAUSE/SLOW.
8. Press
(STOP) to stop editing.
The audio from the microphone is recorded as monaural
audio. Use audio cables to connect audio equipment, etc.,
in order to record in stereo.
If both the MIC socket and the line inputs are connected,
the audio from the MIC socket is given priority in recording.
41