Panasonic PT-61LCZ7 - Manual (Page 7)

7
Getting Start
ed
Remote Control Battery Installation
Requires two AA batteries (supplied).
1.
While pressing in on the catch, open cover in
direction of arrow.
2
. Install batteries in the battery compartment.
Battery polarity (+) and (-) must match the markings
inside the compartment.
3.
Press cover until it snaps shut.
•
< Side view >
30º
30º
At least
1.8 m (PT-50LCZ70/PT-50LCZ7/PT-50LCZ70-K) /
2.0 m (PT-56LCZ70/PT-56LCZ7/PT-56LCZ70-K) /
2.2 m (PT-61LCZ70/PT-61LCZ7/PT-61LCZ70-K).
< Side view >
30º
30º
At least
1.8 m (PT-50LCZ70/PT-50LCZ7/PT-50LCZ70-K) /
2.0 m (PT-56LCZ70/PT-56LCZ7/PT-56LCZ70-K) /
2.2 m (PT-61LCZ70/PT-61LCZ7/PT-61LCZ70-K).
Two AA size Two AA size
Incorrect battery installation can cause the batteries to
leak, leading to personal injury and/or damage to the
Remote Control.
Observe the following precautions:
1. Always replace batteries with a pair of new ones.
2. Do not combine a new battery with an old one.
3. Do not mix battery types (example: “Zinc Carbon”
with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble,
heat or burn used batteries.
5. Battery replacement is necessary when the Remote
Control acts sporadically or stops operating the
Projection Display set.
Reset All Memory Functions
Use when moving unit to a new location, or when First
Time Setup needs to be done over.
Note
When using “EZ Sync™ “HDAVI Control™””, with the device
connected, set “EZ Sync” first to “Off” and then “On” using the
Setup Menu. (p. 52-53)
•
CAUTION CAUTION
Helpful Hints:
(1) Frequent Remote Control users choose
long-lasting Alkaline batteries as replacements.
(2) Whenever batteries are removed, you may need
to reset Remote Control infrared codes.
We suggest making a note of the codes on page 56
prior to setting up the remote.
Helpful Hints:
(1) Frequent Remote Control users choose
long-lasting Alkaline batteries as replacements.
(2) Whenever batteries are removed, you may need
to reset Remote Control infrared codes.
We suggest making a note of the codes on page 56
prior to setting up the remote.
Press together the VOL- button
on the unit and MENU button on
the Remote Control for more than
3 seconds.
After the above message indication
disappeared, unplug the unit then
plug it back in and turn power ON.
Selfcheck in progress.
Please refrain from any
activity. Do not turn off
or unplug the TV.
Selfcheck
Selfcheck in progress.
Please refrain from any
activity. Do not turn off
or unplug the TV.
Selfcheck
Press together the VOL- button
on the unit and MENU button on
the Remote Control for more than
3 seconds.
After the above message indication
disappeared, unplug the unit then
plug it back in and turn power ON.
Selfcheck in progress.
Please refrain from any
activity. Do not turn off
or unplug the TV.
Selfcheck
Selfcheck in progress.
Please refrain from any
activity. Do not turn off
or unplug the TV.
Selfcheck