PhatNoise KDC-W707 - Manual (Page 12)

12 | English
General features
Audio Setup
Setting the Sound system, such as Cross over
Network.
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Front High Pass Filter* 2 "HPF-F" Through/40/60/80/100/
120/150/180/220 Hz
Rear High Pass Filter* 2 "HPF-R" Through/40/60/80/100/
120/150/180/220 Hz
Low Pass Filter* 1,2 "LPF" 50/60/80/100/120/ Through
Hz
Subwoofer Phase* 1,2,3 "SW Phase" Normal (0°)/ Reverse (180°)
Volume offset "VOL Offset" –8 — ±0
Loudness "Loudness" ON/OFF
Dual Zone System "2Zone" ON/OFF
• Volume offset: Sets each source’s volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
• * 1 You can control this item when <Switching preout>
(page 33) is set to "SWPRE:Sub-W". (KDC-W707 only)
• * 1 You can control this item when <Subwoofer
Output> (page 12) is set to "SW ON".
• * 2 You can control this item when "2Zone" of <Audio
Setup> (page 12) is set to "OFF".
• * 3 You can control this item when Low Pass Filter is not
set to Through.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 34).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by <Audio
Control> (page 11).
- The Audio Control has no effect on sub source.
• You can use the Dual Zone System with the Auxiliary
input sources listed below.
- Internal auxiliary input (KDC-W808 only)
- Option CA-C1AX (KDC-W707 only)
5 Exit Audio Setup mode
Press [VOL] knob for at least 1 second.
Subwoofer Output
Turning the Subwoofer output ON or OFF.
Hold down on [AM] of the Control knob for at
least 1 second.
Each time you press the button, Subwoofer
output switches ON and OFF.
When it is ON, "SW ON" is displayed.
• You can control this function when <Switching
preout> (page 33) is set to "SWPRE:Sub-W". (KDC-
W707 only)
• You can control this function when "2Zone" of <Audio
Setup> (page 12) is set to "OFF".