PhatNoise KDC-W707 - Manual (Page 44)

44 | English
Removing the Unit
Removing the hard rubber frame
Insert the removal tool into the indentations in
the hard rubber frame, and pull it gently until the
lock is released.
Removing the Unit
1 Refer to the section <Removing the hard rubber
frame> (page 44) and then remove the hard
rubber frame.
2 Remove the screw (M4 × 8) on the back panel.
3 Insert the two removal tools deeply into the slots
on each side, as shown.
4 Push upward the removal tool toward the top,
and pull out the unit halfway while pressing
towards the inside.
• Be careful to avoid injury from the catch pins on the
removal tool.
5 Pull the unit all the way out with your hands,
being careful not to drop it.
Accessory 5
Removal tool
Accessory 2
Removal tool
Screw (M4X8)
(commercially available)