Messages 100, Under, Standing auto ta and eq error messages on – Pioneer AV Receiver/DVD Payer with 6.5 inch Wide Display AVH-P5700DVD User Manual

Page 100: Error messages, Understanding auto ta and eq error messages, Additionalinformation

Advertising
background image

Error messages

When you contact your dealer or your nearest Pioneer Service Center, be sure to record the error

message.

Message

Cause

Action (See)

ERROR-02

Dirty disc

Clean disc.

Scratched disc

Replace disc.

ERROR-05

Electrical or mechanical

Press RESET.

DIFFERENT REGION DISC (RE-

GION ERR)

The disc does not have the same re-

gion number as this unit

Replace the DVD video with one bearing the

correct region number.

NON PLAYABLE DISC (NON-

PLAY)

This type of disc cannot be played

by this unit

Replace the disc with one this unit can play.

The disc is loaded upside down

Check that the disc is loaded correctly.

THERMAL PROTECTION IN

MOTION (TEMP)

The temperature of this unit is out-

side the normal operating range

Wait until the units temperature returns to

within normal operating limits.

PROTECT

All the files on the inserted disc are

secured by digital rights manage-

ment (DRM)

Replace disc.

TRK SKIPPED

The inserted disc contains WMA

files that are protected by digital

rights management (DRM)

Replace disc.

Understanding auto TA and EQ error messages

When correct measurement of car interior acoustic characteristics is not possible using the auto

TA and EQ, an error message may appear on the display. If an error message appears, refer to the

table below to see what the problem is and the suggested method of correcting the problem. After

checking, try again.

Message

Cause

Action

Error check MIC

Microphone is not connected.

Plug the supplied microphone securely into

the jack.

Error check front SP, Error

check FL SP, Error check FR SP,

Error check center SP, Error

check RL SP, Error check RR SP,

Error check subwoofer

The microphone cannot pick up the

measuring tone of a speaker.

! Confirm that the speakers are connected

correctly.

! Correct the input level setting of the power

amp connected to the speakers.

! Set the microphone correctly.

Error check noise

The surrounding noise level is too

high.

! Stop your car in a place that is as quiet as

possible, and switch off the engine, air condi-

tioner or heater.

! Set the microphone correctly.

AdditionalInformation

En

100

Appendix

Advertising