Setting the speaker setting 77, Setting the speaker setting, Digitalsignalprocessor – Pioneer AV Receiver/DVD Payer with 6.5 inch Wide Display AVH-P5700DVD User Manual

Page 77

Advertising
background image

3 Touch MUSIC and then touch ADJUST.

# You can operate ADJUST only when MUSIC
has been selected.

4 Touch a or b toselect PANORAMA (pa-

norama).

Each time you touch a or b selects the item

in the following order:

PANORAMA (panorama)DIMENSION (di-

mension)CENTER WDT (center width)

5 Touch c to turn the panorama control

on.

# To turn the panorama control off, touch d.

6 Touch b and then touch c or d toad-

just front/surround speaker balance.

Each time you touch c or d it moves the

sound towards the front or the surrounds.

+3  3 is displayed as the front/surround

speaker balance moves from front to sur-

rounds.

7 Touch b and then touch c or d toad-

just the center image.

Each time you touch c or d it gradually

spreads the center channel sound into the

front left and right speakers over a range 07.

3 is the default and its recommended for

most recordings. 0 places all center sound in

the center speaker. 7 places all center sound

equally in the left/right speakers.

Setting the speaker setting

You need to make with/without (or yes/no) and

size (bass reproducing capacity) selection/ad-

justments depending on the installed speak-

ers. The size needs to be set to LARGE (large)

if the speaker is capable of reproducing

sounds of about 100 Hz or below. Otherwise

select SMALL (small).

! Low frequency range is not output if the

subwoofer is set to OFF and the front and

rear speakers set to SMALL or OFF.

! It is imperative that non-installed speakers

be set to OFF.

! Set the front or rear speaker to LARGE if

the speaker is capable of reproducing bass

content, or if no subwoofer is installed.

1 Touch NEXT on the DSP function menu.

2 Touch SP SET.

3 Touch a or b toselect the speaker to

be adjusted.

Each time you touch a or b selects the speak-

er in the following order:

FRONT (front speakers)CENTER (center

speaker)REAR (rear speakers)

SUB WOOFER (subwoofer)PHASE (sub-

woofer setting)

# You can switch to PHASE only when the sub-
woofer has been set to ON.

4 Touch c or d toselect the correct size

for the selected speaker.

Each time you touch c or d selects the size in

the following order:

OFF (off)SMALL (small)LARGE (large)

# You cannot select OFF, when FRONT (front
speakers) have been selected.
# You can select ON or OFF, when
SUB WOOFER (subwoofer) has been selected.
# You can switch REVERSE (reverse phase) or
NORMAL (normal phase), when PHASE (subwoo-
fer setting) has been selected.

DigitalSignalProcessor

En

77

Section

17

DigitalSignalProcessor

Advertising