Pioneer AV Receiver/DVD Payer with 6.5 inch Wide Display AVH-P5700DVD - Manual (Page 89)

Adjusting initialsettings
1
Initial settings lets you perform initial setup of
different settings for this unit.
1 Function display
Shows the function names.
1 Touch the source icon and then touch
OFF toturn this unit off.
# When the source icon is not displayed, you
can display it by touching the screen.
2 Press A.MENU button and touch INIT to
display the initial function names.
The function names are displayed and oper-
able ones are highlighted.
# To go to the next group of function names,
touch NEXT.
# To return to the previous group of function
names, touch PREV.
# When the multi-channel processor (e.g., DEQ-
P8000) is connected to this unit, you can operate
D. ATT and RESET instead of REARSP.
# To return to the previous display, touch BACK.
# To return to the display of each source, touch
ESC.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
% Touch D. WARN on the initial menu to
turn warning tone on.
# To turn warning tone off, touch D. WARN
again.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
% Touch AUX on the initial menu to turn
auxiliary setting on.
# To turn auxiliary setting off, touch AUX
again.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (FULL) or subwoofer (SUB. W)
connection. If you switch the rear output set-
ting to the SUB. W, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (FULL). When rear output is
connected to full range speakers (when FULL
is selected), you can connect the RCA sub-
woofer output to a subwoofer. In this case, you
can select whether to use the subwoofer con-
trollers (low pass filter, phase) built-in SUB.W
or the auxiliary FULL.
! When the multi-channel processor (e.g.,
DEQ-P8000) is connected to this unit, you
cannot operate this function.
InitialSettings
En
89
Section
19
InitialSettings