Palm Tungsten T Handhelds - Manual (Page 168)

Chapter 16 Performing HotSync ® Operations
158
If you’re not sure which option to use, keep the default setting: Always
available.
4. If you are using a serial cradle/cable, click the Local tab to display the settings
for the connection between your computer and the handheld cradle/cable, and
adjust the following options as needed.
If you are using the USB cradle/cable, you do not need to use the settings on the
Local tab for a direct HotSync operation.
5. Click the Modem tab to display the modem settings and adjust the options as
needed. For more information, see
“Conducting modem HotSync operations”
later in this chapter.
6. If you are attached to a network, click the Network tab to display the network
settings and adjust the options as needed. For more information, see
“Conducting network HotSync operations” later in this chapter.
7. Click OK.
Available only when
the Palm Desktop
software is running Starts HotSync Manager and monitors requests
automatically when you open Palm Desktop software.
Manual Monitors requests only when you select HotSync Manager
from the Start menu.
Serial Port Identifies the port that HotSync Manager uses to
communicate with the cradle/cable. If necessary, you can
change the port selection.
Your handheld cannot share this port with an internal
modem or other device.
Speed Determines the speed at which data is transferred between
your handheld and Palm Desktop software. Try the As Fast
As Possible rate first, and adjust downward if you experience
problems. This setting allows your handheld to synchronize
with computer at the fastest speed possible.