Palm Tungsten T Handhelds - Manual (Page 200)

Chapter 17 Setting Preferences for Your Handheld
190
To set the time:
1. From the General Preferences screen, select Date & Time.
2. Tap the Set Time box.
3. Tap the up or down arrows to change the hour.
4. Tap each minute number, and then tap the arrows to change them.
5. Tap OK.
6. Tap Done.
To set the time zone and daylight saving time:
1. From the General Preferences screen, select Date & Time.
2. Tap the Location pick list.
3. Select Edit List.
4. Select the location where you want to set the time zone.
5. Tap Edit to open the Edit Location dialog box.
6. Follow the steps under “Adding a location” in Chapter 15 to select the time zone
and daylight saving time settings.
7. Tap Done.
Digitizer Preferences
The Digitizer Preferences screen opens the digitizer calibration screen. This is the
same screen that appears when you start your handheld for the first time.
You can recalibrate your screen after a hard reset or if your digitizer drifts. You
may need to repeat this process a few times until the calibration registers.
To calibrate your handheld screen:
1. From the General Preferences screen, select Digitizer.
2. Tap the targets as indicated on the screen as precisely as possible.
TIP Remember that you can also select the Preferences category by pressing Left
and Right on the navigator, and that you can select a Preferences screen by pressing
Up and Down on the navigator.