Pioneer DVD-V8000 - Manual (Page 89)

Internal Registers
9. EXTEND TERMINAL CONTROL
To activate a function, create a switch contact with an electrical ground (Pin 1). Check
Chapter 2 to verify pin (Pin 6 through Pin 13) and terminal (SW1 ~ SW8) assignments.
There are three SW functions in the EXTEND TERMINAL CONTROL.
1. To recall Command Stacks and execute
The function, STACK GROUP 1 to STACK GROUP 27, is similar to a combination
of remote control buttons to recall and execute a stack.
2. To execute the function as a remote control command
The function acts the same as the buttons (ENTER, PLAY, STOP, etc.) on a remote
control excluding SCAN FWD/REV.
DVD-V8000 continues execute SCAN FWD/REV even when the button on the
remote control is released. But in case of EXTEND TERMINAL CONTROL, it stops
to execute SCAN FWD/REV when button is released.
(In case of remote control “releasing SCAN button” will not discontinue the SCAN.
But in case of EXTEND TERMINAL, releasing SCAN switch will terminate SCAN
operation.)
3. To execute as an advanced remote control button
Advanced remote control commands such as numbers from 10 to 20 may be sent
as a switch control command.
Note for additional assistance, please refer to Product Information Bulletin (PIB) 152601
DVD-V7400 and Jama Port Control available on the Pioneer Electronics website under
Service & Support – Business Solutions Products.
- 82