Phantom Tech Viewpoint VI0508 - Manual (Page 11)

Adjusting the
Latch
and
Tension Wires
Top Rail
Catch Frame
Latch
Door Frame
Push up the top of the
Catch Frame all the way
into the Top Rail
Adjusting the Latch
Pull the Sliding Bar over to the Catch Frame and
ensure that the Latch can be engaged. If the Latch
cannot be engaged, adjust it by following the
procedure shown in the diagram. Loosen the
screw, adjust the height of the Latch until it
engages with the Sliding Bar. Tighten the screw,
careful not to over tighten.
Adjusting the Tension Wires
1. Slide the Sliding Bar to the opposite end to
engage the Latch. Push the entire mesh over
to the Sliding Bar so that only the Tension
Wires are visible in the opening of the door.
Loosen the screw of the top most Tension Wire
Adjuster. Slide it up or down until snug, without
any sag in the Tension Wire. Tighten the screw
to secure it.
NOTE: do not over tighten the tension on the
Tension Wire.
2. If any of the other Tension Wires are sagging,
perform the same procedure with each adjuster.
If any of the situations below occur, follow the
appropriate procedure to correct the situation.
After adjusting the tension, move the Sliding Bar
two or three times to check the operation of the
Viewpoint Screen.
Loosen the screw
to move up and down.
Tension Wire
Tension Wire
Adjuster
Screw
Keep the topmost Tension
Wire Adjuster fixed, loosen
the remaining Adjusters.
Starting from the bottom
Adjuster, adjust the tension of
each wire to remove the gap
as well as any sag in the
Tension Wires.
To correct this situation,
reverse the steps in
Situation #1 starting from
the top Adjuster. Tighten the tension of the
loose Tension Wire to the
same tension as the other
Tension Wires.
Solution #3
Situation #1 Situation #2 Situation #3
Solution #2 Solution #1
Gap Gap Loose Tension Wire
11