Polycom KIRK KWS1500 - Manual (Page 31)

KIRK Wireless Server 1500 Installation and Maintenance
5. Installation of the KIRK Wireless Server 1500 Solution
5.1 Internal Hardware Installation
In this section we will discuss the physical construction of the KWS1500, and the
installation of the KIRK Expansion Board 1500 and KIRK Analog Interface Cards.
Required tools
• #10 Torx screwdriver
• 3/16”, 1/4”, and 5/16” straight-blade screwdrivers
• #1 and #2 Phillips screwdrivers
• Diagonal wire cutters
• Long-nosed pliers
• Electrician’s pliers
• Slip-joint pliers
• Standard crimping tool
• Adjustable wrench
• Socket wrench set
• Telephone cable cutters
• Telephone cable insulation strippers
• 16-foot (5 m) measuring tape
• Punch tool matching all telephone cable termination blocks used at the installation
site
• Digital multi-meter (DMM)
• Telephone line test set capable of pulse and DTMF dialing
• Portable (laptop) personal computer capable of emulating an asynchronous ASCII
data terminal and approved by the manufacturer to run the binary database save and
restore utility, or
portable asynchronous ASCII data terminal, or
permanently installed, on-site, personal computer or ASCII data terminal
Optional tools
• Modular line polarity tester
• Flashlight
• Tone/continuity/talk battery generator
• Tone detector/amplifier probe
• Telephone line test set with MF tone signaling capability
• Alligator clip leads
• 3/16” and 1/2” cable staple gun
• Analog transmission analyzer
72160400_issue_B 31