Panasonic MC-V5203 - Manual (Page 9)

- 9 - - 12 -
EXPLODED VIEW (PACKAGING)
PARTS LIST (PACKAGING)
2
1
b
a
e
d
Operating
Instructions
Unit Bag
(Handle)
Unit Bag
(Power Cord)
Carton
Cushion “B”
Cushion “A”
f Packing
Insert
c Unit Bag
(Body)
g
Unit Bag
(Attachment
Assembly)
i
Pedal
Protector
Ref. No. Part Name & Description Part No. Quantity Remarks
1 Packaging Assembly AC61ZCCAZØØØ 1 Includes 1 and items a-i
2 Operating Instructions ACØ1ZCCAZØØØ 1
When to replace brushes
1. The agitator brushes should be replaced when they are worn. Brushes should be checked by
holding a card across the lower plate, (Fig. 5). If the bristles on the agitator assembly do not
touch the card you should replace all the brushes for best cleaning results.
Removal
NOTE: Use extreme care when prying or depressing these items with a screwdriver in
order to help prevent personal injury or damage to the vacuum.
Be careful when working around the ends of the metal brush holder since sharp edges
may be present.
1. Remove the lower plate as outlined in the LOWER PLATE REMOVAL/
INSTALLATION section.
2. Remove the agitator assembly as outlined in the AGITATOR ASSEMBLY
REMOVAL/INSTALLATION section.
3. The agitator assembly may now be dissassembled and the brushes replaced.
4. Using a small screwdriver, carefully remove the E-clip from the agitator shaft,
(Fig. 6), DO NOT misplace. Remove the right end cap. Pull the agitator shaft out of the opposite
end of the agitator.
5. Pull or pry out the agitator pulley and agitator holder, (Fig. 7).
6. The brushes can now be replaced, (Fig. 8). Each brush must be inserted so that the end with
eleven (11) tufts is placed on the side of the brush holder closest to the belt pulley. Push each
brush as shown in the illustration until it is free from the agitator body. Install the new brushes by
reversing the procedure.
Installation
1. Pull the new brushes into the slots in the brush holder.
2. Reinstall the agitator holder and agitator pulley, making sure they are completely
and firmly inserted. See (Fig. 9) for an exploded view.
3. Reinstall the agitator shaft, brush support, and the small E-clip.
4. Reinstall the agitator assembly as outlined in the AGITATOR ASSEMBLY
REMOVAL/INSTALLATION section.
5. Reinstall the lower plate as outlined in the LOWER PLATE REMOVAL/
INSTALLATION section.
NOTE: When the brushes are properly installed they will not hit the lower plate
as the agitator assembly rotates.
BRUSH REPLACEMENT
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
E- Clip
Filter
Agitator Holder
Agitator
Body Spacer
Belt Pulley
End Caps
Agitator Shaft
Brush
Filter
AGITATOR ASSEMBLY
(Fig. 8)
(Fig. 9)