POSIFLEX Business Machines TP-6000 SERIES - Manual (Page 31)

TP6000 USER’S MANUAL 5 - 7
also be obtained through downloading from our web site. Application of this program
provides control over the MSR, the touch panel and the power control of the Posiflex
Touch Terminal. For an RS232 interfaced touch panel, the touch panel part of the
following description should be disregarded and please refer to the paragraph “RS232
TOUCH MONITOR MOUSE” instead.
This program controls software gating of data read from each MSR track and
the way data is sent from the reader to the system including the coding method against
language systems, data transmission speed, delivery and selection on leading/ending
code of each track to be sent to the system.
This program also controls the beep generated when the touch panel is
touched, the detail in right button click emulation and provides touch panel re-
calibration.
This program can also be used to define the power switch to be on only or
on/off switching, the delay time before software power off and whether an UPS
battery is engaged in the power control system.
RS232 TOUCH MONITOR MOUSE
If the product model purchased is TP6012R or TP6015R, the touch panel
controller used is the RS232 interfaced controller. The “Touch Panel Manager” of the
above “Posiflex Touch Terminal Manager” should be discarded and a separate
software Monitor Mouse should be used. In these models, the connector COM2 will
be plugged with a cover to inhibit any use of this port other than the connected RS232
touch controller. Removal of this cover voids the product warranty!!
In principle, the driver for the RS232 touch controller is installed with the
systems equipped with the RS232 touch controller. However, if a re-installation is
required, please select “SmartSet Serial Controller on COM2” for controller type
selection during the installation process.
Once the RS232 touch controller is installed, the user can utilize it to calibrate
the touch screen, to define mouse button emulation mode, to enable right button
emulation or to define the click sound’s tone and duration. Please click “Start”,
“Setting”, “Control Panel” and “Elo Touchscreen” to engage this utility.