Pentax Optios7 - Manual (Page 73)

71
Tak
ing Pi
cture
s
4
You can switch the Drive mode to Remote Control mode and take
pictures using the remote control unit E or F (optional).
1
Press the four-way controller (2) in Capture mode.
2
Use the four-way controller
(45) to select i or h.
3
Press the OK button.
The self-timer lamp blinks slowly and the
camera is ready to take the picture.
4
Press the shutter release button
on the remote control unit.
i The self-timer lamp blinks quickly and the picture is taken after
approximately three seconds.
h The picture is taken immediately.
Using the Remote Control Unit (optional)
Taking Pictures Using the Remote Control
• Focusing may be compromised if you move the camera while the
self-timer lamp is blinking.
• You cannot use the remote control unit in Movie mode.
Shutter release button
Zoom button
Remote control unit E
(Remote control unit F
has no zoom button.)
Four-way
controller
OK button
OK OK OK OK
Drive Mode Drive Mode
0 sec remote control 0 sec remote control
Drive Mode
0 sec remote control